-4-
Optional Bracket Mounting
(Deck, Mirror, or Suction Cup)
MOUNT
THROUGH
BRACKET
CAUTION:
Take extreme caution not to over tighten the screws!!! Over
tightening of the screws can strip the holes and result in a faulty mount.
1. Decide which side you want the cord to exit
the light and determine which way you will
need to mount the ULB9-BKT to your light.
2. Attach Part A of the mounting bracket, facing
the direction you have selected, to the light by
using two of the Philips head screws.
A
A
B
3. Use two Philips head screws,
two flat washers,
and two tooth washers
to attach Part B of the
mounting bracket to
Part A.
5. If you are utilizing the suction cup mount, attach the suction
cups to the mounting bracket. Then mount the light in the
desired location and skip to step 9.
CAUTION: Take extreme caution not to over tighten the suction
cups!!! Over tightening of the screws can strip the holes or
puncture the inside of the cup resulting in a faulty mount
.
6. If you are using the Mirror Mounting Clamp to mount your light to your rear
view mirror, it is the sole responsibility of the installer to ensure that the
rear view mirror mount can support the light you are installing.
9. Once the light is secured, route your cord such that it does not interfere with the vision of
the driver or the operation of the steering wheel, gear shifter, and/or any airbags.
7. Place the clamp around the mirror stem.
8. Attach the clamp to the bracket with the washer, nut and
bolt, securing your light to the rear view mirror.
4. If you are mounting the light directly to the rear deck, dash,
or other suitable surface, you may use appropriate
fasteners (not supplied) to attach the bracket to your
mounting surface and skip to step 9.
(Optional mounting kit 274-ULB9-BKT sold separately)
