-2-
Proper installation of the unit is essential for years of safe, reliable operation. Please
read all instructions
before
installing the unit. Failure to follow these instructions can
cause serious damage to the unit or vehicle and may void warranties.
Qualifications
The installer must have a firm knowledge of basic electricity, vehicle electrical
systems and emergency equipment.
Keep These Instructions
Keep these instructions in the vehicle or other safe place for future reference.
Advise the vehicle operator of the location.
Unpacking
Inspect contents for shipping damage. If any damage is found, alert the carrier
immediately.
Installation Notes
!!! CAUTION !!!
•
Mount in a location with adequate ventilation to prevent overheating.
•
Devices should be mounted only in locations listed in SAE standard J1849.
•
Controls should be placed within convenient reach of the driver.
•
Assure clearances before drilling in vehicle.
•
Sound levels produced by attached speakers can cause permanent hearing loss.
•
Never operate this unit without adequate hearing protection for you and others in the
area. (OSHA 1910.95)
Mounting
CONTROL HEAD
The control head is designed to be mounted in an easily accessible
location such as under the dash, in the overhead console, or in a
center console. Choose a mounting location convenient to the
operator and away from any air bag deployment areas. Be sure to
choose a location that has at least two inches of depth to
accommodate the control head and cables. Consider wire routing
and access to connections when selecting location as well.
•
Using the switch panel unit itself as a template, mark the location of the two mounting
holes to be drilled. Be sure to check for obstructions behind the mounting hole locations.
•
Drill the two mounting holes and install the control using two screws or other suitable
fastener (not provided).
AMPLIFIER BOX
The amplifier box should be mounted through its flanges using four #8 screws (not included)
or other suitable fastener.
•
Using the amplifier as a template, mark the
location of the four mounting holes to be
drilled. Be sure to check for obstructions
behind the mounting hole locations.
•
Drill the four mounting holes and secure
the amplifier box using appropriate
hardware (not supplied).
