-5-
P
h
a
s
e
1
P
h
a
s
e
2
F
la
s
h
P
a
tt
e
rn
#
P
a
tt
e
rn
T
y
p
e
Pattern Description
Shortcut
1
11
A
Fast Singleflash (1.9 CPS)
Pattern 1
(Phase 1)
:
3 sec or 1 flash
Pattern 11
(Phase 2)
:
9 sec or 3 flashes
2
12
B
Flicker flash (1.7 CPS)
3
13
C
Post pop (1.4 CPS)
4
14
D
PSU-flicker (0.4 CPS)
5
15
E
Random (1.9 CPS)
(DEFAULT PATTERN)
6
16
F
Quadflash (1.0 CPS)
Pattern 6
(Phase 1)
:
6 Sec or 2 flash
Pattern 16
(Phase 2)
:
12 sec or 4 flashes
7
17
G
Quadflash
w/Post-Pop (1.0
CPS)
8
18
H
Singleflash (1.0 CPS)
9
19
I
Doubleflash (1.0 CPS)
10
20
J
Delta-Omega (0.3 CPS)
B. Opposite Light Function
When your lights are activated in Warning Mode and you turn on your Turn Signal (blinker),
the corresponding head will flash in conjunction with your turn signal. By default, the
opposite
light will illuminate in a steady burn mode. If instead you would like the
opposite
light to continue flashing in the pre-programmed warning pattern or turn OFF when the Turn
Signal is activated, proceed below:
Connect the Black, Red, and White wires as indicated below. When you hold the Green
wire to ground, the light will flash every 3 seconds. After 3 seconds it will blink once, after 6
seconds it will blink twice, after 9 seconds it will blink 3 times, and so on. Use the chart
below to determine the proper length to Hold the Green wire to program the desired mode.
Opposite Turn Signal Programming Summary
Black
- Ground
Red
- Power
White
- Power
Green
- To program touch to Ground
Release Green After:
Opposite Light Mode
Triple Blink (9 sec)
Steady Burn Mode
Quad (4) Blink (12 sec)
OFF
Quint (5) Blink (15 sec)
Warning Pattern
Once the light flashes the appropriate number of times, remove the Green wire from
Ground, then
wait 1 second
and remove the White wire from power.
(PROGRAMMING CONT'D)
C. Warning Pattern Programming
Please note the following points when programming the pattern:
DO NOT CONNECT THE WHITE SYNCHRONIZATION WIRES TOGETHER UNTIL
EACH LIGHT HAS BEEN PROGRAMMED SEPARATELY!!!
Each light has 10 different
Pattern Types
you can cycle through (A-J) in two
different
Phases
.
If you will be synchronizing two heads (most applications), the two heads MUST be
programmed for the same
Pattern Type
.
Lights programmed for the same Phase will flash the same, while lights programmed
for different Phases will flash opposite one another.
If you are running in "Split Mode", the two halves will alternate the pattern back and
forth.
For lights running in Split Mode, Patterns 1-10 flash side 1 in Phase 1 and side 2 in
Phase 2. Patterns 11-20 flash side 1 in Phase 2, and side 2 in Phase 1.
Pattern Programming Summary
Black
- Ground
Red
- Power
Green
- To program touch and
release to Ground
Pattern Shortcuts:
Hold Green wire to
ground for indicated time.
