-1-
These lights are NOT designed to replace the standard Turn Signals or Hazard lights on your vehicle.
These lights are NOT designed to act as STOP or Brake lights.
These lights, when activated via a user-supplied switch, will flash in a pre-programmed warning
pattern that is selected at the time of installation.
If these lights are powered up, and a Turn Signal (blinker) is activated, the corresponding light will
mimic the flashing of the Turn Signal. The opposite light will either remain in the warning pattern
mode, deactivate (turn OFF), or become Steady Burn, depending upon initial programming of your
lights at the time of installation.
Functionality
Installer must have firm knowledge of vehicle electrical systems & emergency equipment.
It is the
sole responsibility of the installer to ensure the warning light is secure. The manufacturer
assumes no responsibility for the secure mounting of this light.
If you need to drill any holes when installing this light, please take care to check that BOTH SIDES of
your drilling surface are clear from obstructions.
Use only soap and water when cleaning product. Use of other chemicals may discolor lens and/or
housing, diminishing light output. Replace discolored lenses immediately!
Installation Notes
