-1-
Mount The Minibar/Worklight Assembly To The Vehicle
1. Using the gasket as a template, mark the three or four
mounting holes and the center wire hole (if you will be
needing one).
2. Use an 11/64” bit to drill out the 3 or 4 holes that you
marked on the vehicle mounting surface.
3. Use a 1/2” drill to drill out the center wire hole (if needed).
4. Route your wires through the center hole of the gasket
and mounting surface (if applicable)
5. Attach the Minibar/Worklight assembly using the enclosed
#8-32 X 3/4" 18-8 hex head screws (for mounting surfaces
3/16”-3/8” thick), flat washers, and tooth washers as
shown to the left. . Insert the bolts from below, fastening
them into the same
threaded inserts
used to attach the
worklight inside the minibar. Tighten until snug.
(Note: Use longer bolts if your mounting surface is thicker than 3/8”)
The model you received has been designed to be compatible with a Go Light™ GT, Radio
Ray, Stryker, Stryker Hardwire, Stryker ST Series (or most other worklights with identical
mounting patterns). For proper installation, first mount the worklight to the minibar, then
mount the minibar/worklight assembly to the vehicle.
Mount The Worklight To The Minibar
1. Use an 11/64” bit to carefully drill out the 3 or 4
holes in the dome that correspond with the
mounting pattern of your worklight. Ensure that
your bit is perpendicular to the surface of the dome.
2. Use an 1/2” drill to drill out the center post hole of
the dome to allow for wire access.
3. Following the manufacture’s instructions for the worklight,
remove the base from the worklight.
4. Place the worklight base on the top of the minibar dome and
align the corresponding holes.
5. Use the #8-32 X 1-1/4" 18-8 pan head mounting screws and
washers provided with the minibar to attach the worklight base to
the minibar (4-screw version shown).
6. Route the wire harness from the worklight through the center
hole in the worklight base and the minibar dome and follow the
manufacturer’s instructions included with your worklight to
reassemble it to the base.
Mounting Instructions
(when used with optional Worklight)
IMPORTANT:
Please read all of the following instructions before installing your new light.
4-Hole Layout
3-Hole Layout
