Star Cooperation 3-01000A01-01, Instructions For Use Manual, Page: 16 / 18

Created by STAR ELECTRONICS GmbH & Co. KG
Date created 2020-11-04 Date modified 2020-11-04 Page 16 of 18
3
7
-0
0
1
-T
0
8
_I
nst
ru
ct
io
n_
fo
r_
U
se
_D
1
V
9
-F
8 Appendix
8.1 Appendix A: Guideline for handling ESD sensitive Products
 Any tester, equipment, or tool used at any production step or for any manipulation of semi-
conductor devices must have its shield connected to ground.
 The product itself and the carrier system of the product respectively must be placed on a
conductive table top or covered by an antistatic surface (superficial resistivity equal to or higher
than 0.5M
Ω
/cm
2
), grounded through a ground cable (conductive cable from protected equipment to
ground isolated through a 1M
Ω
 resistor placed in series).
 All manipulation of finished goods has to be made at such a grounded worktable.

The worktable must be free of all non-antistatic objects.
 An antistatic floor covering grounded through a conductive ground cable (with serial resistor
between 0.9M
Ω
and 1.5M
Ω
) should be used.
 It is recommended that you wear an antistatic wrist or ankle strap, connected to the antistatic floor
covering or to the grounded equipment.
 If no antistatic wrist or ankle strap is worn, touch the surface of the grounded worktable before
each manipulation of the ESD sensitive product.
 It is recommended that antistatic gloves or finger coats be worn.
 It is recommended that nylon clothing be avoided while performing any manipulation of parts.
8.2 Appendix B:
8.2.1 Acronyms and Abbreviations
Item Definition
BD Bus driver
BP Bus plus
BM Bus minus
ECU Electronic Control Unit
EMC Electromagnetic Compatibility
ESD Electro Static Discharge
NC Not Connected
PCB Printed Circuit Board
PL Physical Layer
8.2.2 List of Tables
Table 1: Electrical characteristics ......................................................................................................................... 8
Table 2: Physical characteristics ........................................................................................................................... 8
Table 3: Environmental conditions ........................................................................................................................ 8
Table 4: Power cable ............................................................................................................................................ 9
Table 5: Connector for D-Sub (2-wire ethernet) ................................................................................................... 11
8.2.3 List of Figures
Figure 1: Side with Power and Ethernet (1000BASE-TX) ........................................................................................ 9
Figure 2: Side with 1000BASE-T1 ......................................................................................................................... 9
Figure 3: Ethernet connector with yellow and green LED ..................................................................................... 10
Figure 4: LED for IEEE(A2) (yellow) and the DIP-switches .................................................................................... 11