Star Cooperation 3-01000A01-01, Instructions For Use Manual, Page: 9 / 18

Created by STAR ELECTRONICS GmbH & Co. KG
Date created 2020-11-04 Date modified 2020-11-04 Page 9 of 18
3
7
-0
0
1
-T
0
8
_I
nst
ru
ct
io
n_
fo
r_
U
se
_D
1
V
9
-F
Figure 1: Side with Power and Ethernet (1000BASE-TX)
Figure 2: Side with 1000BASE-T1
3.4.1 Power
The valid range of the power supply for the FlexMedia 1000BASE-T1 is within 8 - 48 V DC. The power
supply input of the FlexMedia 1000BASE-T1 is reverse protected.
The green LED near the power cable shows the power supply status, if the LED is on, the power is OK.
Power cable
Pin Signal Name Description
1 GND Ground signal
2 Uin Power in allowed in the range from 8 – 48 V
Table 4: Power cable
3.4.2 Ethernet (RJ45)
The FlexMedia 1000BASE-T1 support a 100 or 1000BASE-TX (100 or 1000 MBit/s Ethernet) interface at
the Ethernet connector. This connector supports both 100MBit/s and1000 MBit/s in full-duplex mode. 10
MBit/s mode and half-duplex mode are not supported.
NOTICE
The maximum allowed length of the Ethernet cable is 30m.