12 ► ZGG81
User Manual
continuing.
10. Start the grinder and move the grinding wheel to
the work surface.
NOTE: Rest your leg against the leg brace to increase
your leverage on the grinding wheel.
11.
Grind a small amount of material at a time.
12.
Grind the web, then move grinder over the rail
head and grind the second web.
13. When finished, turn off the power supply and
disconnect the hose whips.
14.
Release handle lock (see figure 2) and rest the
handle back in the cradle and lock in place.
15. Lift up and rotate clamp lever (see figure 1) and
remove grinder from rail.
COLD WEATHER OPERATION
If the grinder is to be used during cold weather, preheat
the hydraulic fluid at low engine speed. When using the
normally recommended fluids, fluid temperature should
be at or above 50 °F/10 °C (400 ssu/82 centistokes)
before use.
OPERATION
OPERATION
1. Before placing the unit on the rail, loosen
Rear
Adjuster
(see figure 1), raising the
Roller
.
2. Open the
Wheels
by lifting the
Clamp
Lever
and
rotate wheels so they are sideways.
3. Place on rail, lift and rotate
Clamp
Lever/wheels
and lock the pin in place.
4. Tighten
Rear Adjustor
until the roller touches rail,
do not over tighten
, the clamp will roll freely.
5. Pull
Handle Lock Release
(see figure 2) and lift
handle to the operating position. Verify the lock is
engaged in the side plate.
6. Connect hose whips.
7.
Rotate the motor to the side of rail to be ground.
8. Move the hydraulic circuit control valve to the
ON
position
9. Squeeze the trigger momentarily. If the grinder
does not operate, the hoses might be reversed.
Verify correct connection of the hoses before
Rear Adjuster
Roller
Clamp Lever
Wheels
FIGURE 1
Handle Lock
Release
Operating Position
Hose Coupler
Trigger
Cradle
Leg Brace
FIGURE 2
