Stanley STPT0900, Original Instructions Manual

Page: 6 / 30

6
ENGLISH (Original instructions)
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
• This appliance is not intended for use by young or infirm
persons without supervision. Children must be
supervised to ensure they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised STANLEY Service Centre
in order to avoid a hazard.
Residual risks
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks cannot be avoided. These include:
• Injuries caused by touching any rotating/moving parts.
• Injuries caused when changing any parts, blades or
accessories.
• Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods make sure you take
regular breaks.
• Impairment of hearing.
• Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF).
Features (Fig. 1)
A. Trigger Switch
B. Main Handle
C. Secondary Gripping Handle
D. Adjustable Shoe Screws
E. Adjustable Shoe
F. Blade Clamp
Assembly and Adjustment
Warning: CUT HAZARD. Turn off and
disconnect tool from power source before
making any adjustments or removing or
installing attachments or accessories.
Warning : Hold saw firmly with both hands for all
cutting operations.
Warning : Inspect work area for hidden electrical
wiring, gas pipes or water pipes before making
blind or plunge cuts. Failure to do so may result
in electrica lshock, fire, explosion, or property damage.
Warning: CUTHAZARD . Blade breakage may
occur if the blade does not extend past the shoe
and the workpiece during the cut. Increased risk
of personali njury, as well as damage to the shoe and
workpiece may result.
Warning: ALWAYS use safety glasses.
Everyday eyeglasses are NOT safety glasses.
Also use face or dust mask if cutting operation is
dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT.
Warning: CUT HAZARD. Before cutting any type
of material, be sure it is firmly anchored or
clamped to prevent slipping.
• Switch on saw motor before applying pressure.
• Place blade lightly against work to be cut.
Warning:CUT HAZARD. Never hold and use
the product with your fingers wrapped around
shoe adjustment button. Always hold saw firmly
with both hands while cutting as shown in Figure 2.
Whenever possible, the saw shoe must be held firmly
against the material being cut. This will prevent the saw from
jumping or vibrating and minimize blade breakage.
Variable speed switch (fig.3)
The variable speed trigger switch will give you added
versatility. The further the trigger is depressed the higher the
speed of the saw. To turn the tool “OFF” release the trigger.
Warning: CUTHAZARD. This tool has no
provision to lock the switch in the ON position,
and should never be locked in the ON position by
any other means.
Blade installation and removal(fig.4)
Warning: CUT HAZARD. Turn off and
disconnect tool from power source before
making any adjustments or removing or
installing attachments or accessories. The blade should
extend past the shoe and the thickness of the workpiece
during the cut. Select the blade best suitable for the material
to be cut and use the shortest blade suitable for the
thickness of the material. Do not use jigsaw blades with this
tool.
Warning: CUT HAZARD. Blade breakage may
occur if the blade does not extend past the shoe
and the workpiece during the cut. Increased risk
of personal injury, as well as damage to the shoe and
workpiece may result.