10 ENGLISH
20
21
22
23
24
25
Too much dust and paint
on the compressor.
Water is mixed with the oil
(milky coloration).
Ambient temperature below minimum
recommended 5
˚
C (41
˚
F).
Operating too long below
pressure of 60 psi (4.0 bar).
Pressure regulator valve not adjusted
(Fig.
H
)
Relief valve not seal because
of impurities.
as indicated in
Fig. B - Page 2
Clean the compressor externally.
Change the lubricant oil and run
your pressure compressor for
15 min, at a maximum pressure of
100 psi (7.0 bar). This will remove
any internal condensation signs
inside pump.
Run the equipment above 5
˚
C
(41
˚
F)
Compressed air consumption
higher than compressor’s flow.
Adjust it.
Send compressor to the nearest
StanleyBlack&Decker
Authorized Center
