ENGLISH (
Original Instructions)
22
♦
Maintain a firm grip on the power tool and position
your body and arm to allow you to resist kickback
forces. Always use auxiliary handle, if provided,
for maximum control over kickback or torque
reaction during start up.
The operator can control
torque reaction or kickback forces, if proper precautions
are taken.
♦
Never place your hand near the rotating accessory.
Accessory may kickback over your hand.
♦
Do not position your body in the area where
power tool will move if kickback occurs.
Kickback
will propel the tool in direction opposite to the wheel’s
movement at the point of snagging.
♦
Use special care when working corners, sharp
edges etc. Avoid bouncing and snagging the
accessory.
Corners, sharp edges or bouncing have a
tendency to snag the rotating accessory and cause loss
of control or kickback.
♦
Do not attach a saw chain woodcarving blade
or toothed saw blade.
Such blades create frequent
kickback and loss of control.
Additional Safety Information
♦
Do not use Type 11 (flaring cup) wheels on this tool.
Using inappropriate accessories can result in injury.
♦
Always use side handle. Tighten the handle
securely.
The side handle should always be used to
maintain control of the tool at all times.
♦
Use clamps or another practical way to secure
and support the work piece to a stable platform.
Holding the work by hand or against your body leaves it
unstable and may lead to loss of control.
PERSONAL SAFETY
♦ No children or pregnant women should enter the work
rea where the paint sanding is being done until all
cleanup is completed.
♦ A dust mask or respirator should be worn by all persons
entering the work area. The filter should be replaced
daily or whenever the wearer has difficulty breathing.
Note: only those dust masks suitable for working with lead
paint dust and fumes should be used. Ordinary painting
masks do not offer this protection. See your local hardware
dealer for the NIOSH approved proper mask.
ENVIRONMENTAL SAFETY
♦ Paint should be removed in such a manner as to
minimize the amount of dust generated.
♦ Areas where paint removal is occurring should be
sealed with plastic sheeting of 4 mils thickness.
♦ Sanding should be done in a manner to reduce tracking
of paint dust outside the work area.
LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear ear protection.
Wear safety glasses or goggles.
V
Volts
Direct Current
A
Amperes
n
0
No-Load Speed
Hz
Hertz
Class II Construction
W
Watts
Earthing Terminal
min
minutes
Safety Alert Symbol
Alternating
Current
/min.
Revolutions or
Reciprocation per
minute
Position of Date Code (Fig. A)
The Date Code (10), which also includes the year of
manufacture, is printed into the housing.
Example:
2017 XX JN
Year of manufacturing
PACKAGE CONTENTS
The package contains:
1 Angle Grinder
1 Guard
1 Flange set
1 Spanner
1 Handle
1 Instruction Manual
♦ Check for damage to the tool, parts or accessories
which may have occurred during transport.
♦ Take the time to thoroughly read and understand this
manual prior to operation.
ELECTRICAL SAFETY
Your tool is double insulated; therefore no earth wire
is required. Always check that the main voltage
corresponds to the voltage on the rating plate.
Warning!
If the power cord is damaged, it must be
replaced by the manufacturer, authorized Stanley
Service Center or an equally qualified person in order
to avoid damage or injury. If the power cord is replaced
by an equally qualified person, but not authorized by
Stanley, the warranty will not be valid.
