27
O R I G I N A L I N S T R U C T I O N
9. TROUBLESHOOTING GUIDE
Symptom
Cause
Remedy
Tool does not operate
when trigger is pressed.
Battery is defective
Replace battery
Battery is not fully charged
Charge battery (4.3.1)
Battery is not fully seated
Remove battery and re-insert. Reset
tool to home.
Battery pack has reached
operating temperature limit
through continuous use or
defect.
Remove battery & allow to cool.
Mount battery and reset tool to home.
Tail Jaw Cartridge not detected
Insert Tail Jaw Cartridge to the tool
LED Flashing (1s intervals)
Tool is in reload mode. Hold trigger for
>1s to reset to home position
Tail Jaw Cartridge cover open
Close cartridge cover and lock in place
with Cartridge catch
Tool does not return
to initial position when
trigger is released.
Electrical malfunction.
Remove battery, wait 2 seconds
then reinsert. Reset tool to home by
operating trigger (4.2.2)
Stroke Selector will not
rotate
Tool not at home position
(stuck in reload mode)
Pull trigger for >1s until LED fl ashes at
regular 1 second intervals. Position the
mandrel, pull trigger for >1s to return
the tool to home position.
Quickly double tap the trigger in
reload mode to revert the tool to
home position
Battery removed from tool mid-
stroke
(tool is stuck in placing mode)
Tool is in placing mode, reload battery
to tool and pull trigger to actuate.
Tool overload in application
(Placing mode)
Check application (hole sizes sheet
thicknesses) to specifi cation.
In Placing mode, pull trigger
<0.5second and release trigger to
reset position.
Tool stuck in application
(tool is stuck in placing mode)
Mandrel will need to be destroyed to
release tool. (grind mandrel head off)
Tool will not place fastener
Battery is defective
Replace battery
Battery charge is low
Recharge battery
High broach load
Check fastener grip and application
hole size
Check for correct size mandrel
Worn or broken tail jaws
New tail jaws (5.3.2)
Worn or broken nose jaws
New nose jaws
Clutch noise when placing
fastener
Tool is overloaded in application
Check application (hole sizes sheet
thicknesses) to specifi cation.