9
ENGLISH
A. Fit Locking Ring 10 over Jaw Spreader Housing (
24
).
B. Coat Screw (
13
) with thread locking adhesive and use to secure Nose Tip (14) onto Body (
5
).
C. Lightly lubricate items (
17
), (
18
), (
19
), (
20
) and insert into Jaw Carrier (
3
) as shown. Secure with Screws (
16
).
D. Position Lever (
4
) into Body (
5
) and hold in place with pin (
15
) through the hole of Body (
5
) (not a slot).
E. Lubricate the sides of the Jaw Carrier Assembly and insert into Body (
5
).
F. Lubricate Rollers (
8
) and ENSURE that they will freely rotate in the holes of Adaptor (
9
). If necessary ream
the holes.
G. Position Spring Clip (
7
) over Adaptor (
9
) past the holes for the rollers and rotate until the locating peg is
aligned with the corresponding hole in Adaptor (
9
) (smallest hole).
H. Fit Adaptor (
9
) over the end of Body (
5
) and drop Rollers (
8
) into place. Push Spring Clip (
7
) over Rollers (
8
).
I. Insert Spindle (
11
) through Adaptor (
9
) into Jaw Carrier (
3
) until the hole lines up with slot in Body (
5
).
Temporarily hold in place with Pin (
6
).
J. Insert Pin (
12
) through the front slot of Body (
5
) into Jaw Carrier (
3
).
K. Hold the assembly vertical to prevent all pins dropping out and slide the jaw carrier assembly back and
forth a few times to ensure free movement. Go to M.
L. Remove Screws (
23
) (4 off) and Guard (
1
). On a straight swivel head also remove Screw (
21
) and Platform (
22
).
M. Push Pin(s) (
6
) out and let Spindle (
11
) drop out. Screw Spindle (
11
) onto the Jaw Spreader Housing (
24
),
leaving the small screw fixing hole uppermost for straight swivel. Tighten gently with a tommy bar.
N. Screw the assembly over Spindle (
11
) onto the tool. Replace Pin(s) (
6
).
O. On straight swivel heads attach Platform (
22
) onto the top of the Spindle (
11
) with Screw (
21
). Deburr the
back end of Platform (
22
) so that it cannot catch on Guard (
1
).
P. Snap Guard (
1
) over the assembly, align screw holes in guard with tapped holes in body assembly.
Q. Insert Pivot Pin (
15
) through slots in guard and hole in body. Fit Circlip (
2
) onto pivot pin so that the circlip
seats in groove provided.
R. Coat the thread of Screws (
23
) (4 off) with thread locking adhesive and screw into body assembly
securing guard to body assembly.
RIGHT-ANGLE SWIVEL HEAD
Fig. 8
Summary of Contents for ProSet XT3
Page 23: ...23 ENGLISH...
