Stanley ProSet XT3, Instruction Manual

Page: 6 / 24

6
ENGLISH
Table 2 - RIGHT-ANGLE SWIVEL HEAD Capability
RIVET
TYPE
RIVET DIAME-
TER
RIVET
MATERIAL
SWIVEL
HEAD
NOSE
TIP
DIMENSIONS
JAWS
A B
AVEX
AL. ALLOY
STEEL
AL. ALLOY
STEEL
AL. ALLOY
BULBEX
AL. ALLOY
AL. ALLOY
AVINOX
ST. STEEL
ST. STEEL
AVSEAL II
AL. ALLOY
AL. ALLOY
AL. ALLOY
AL. ALLOY
STAVEX
STEEL
STEEL
ST. STEEL
ST. STEEL
360 rotation
Fig. 3 Fig. 4
PREPARING THE BASE TOOL TO ACCEPT SWIVEL HEAD EQUIPMENT
IMPORTANT - READ THE SAFETY WARNINGS LISTED IN THE PROSET XT3 AND PROSET XT4 INSTRUCTION
MANUAL CAREFULLY BEFORE PUTTING INTO SERVICE.
IMPORTANT - THE AIR SUPPLY MUST BE TURNED OFF OR DISCONNECTED BEFORE FITTING OR
REMOVING THE SWIVEL HEAD NOSE ASSEMBLIES.
Refer to fig. 5 and fig. 6 and the table on page 10.
• The air supply must be disconnected.
• Rotate the Stem Collector (76003-05200) anti-clockwise and remove from the Collector Adapter (76003-
05104).
• Unscrew and remove the Deflector Retaining Nut (76003-05102) together with the Stem Deflector (76003-
05101).
• Place the Collector Adapter Cover ( 27 ) over the Collector Adapter (76003-05104) and then install Safety
Cap ( 26 ) until the end face of the Collector Adapter Cover ( 27 ) is secure against the mating face of the
Collector Adapter (76003-05104).
• If necessary, remove the complete Nose Assembly (76003-15000) as described on page 9 of the Proset
XT3 and Proset XT4 instruction manual.