70
psi
120
psi
2
Attach
air
hose to regulator
outlet.
Adjust
regulator knob so
outlet pressure is
between 70 psi and
120 psi.
1
Close
pressure
regulator,
Turn
ON
compressor and
Allow
tank to reach
maximum pressure.
NOTICE: To operate this tool you will need
at least a 1 gallon compressor.
Setup
Like a Pro
CHN70800 — Air Powered Framing Nailer
3-1/2 inch 34° Framing Nailer
CHN70800
IN727801AV 6/09
Setup
Like a Pro
Easy Setup Guide
Projects are easier with
Campbell Hausfeld
products.
Thank you for deciding to purchase a
Campbell Hausfeld product. We are dedicated
to providing tools that help you to complete your
projects
Like a Pro
.
© 2009 Campbell Hausfeld/Scott Fetzer
© 2009 Campbell Hausfeld/Scott Fetzer
Load
fasteners. See manual for further information regarding
length and type of fasteners.
Load
nails into rear slot of magazine.
Pull
pusher back over nail clip.
Release
pusher.
3
Attach
coupler
on air hose to
nailer inlet.
4
se to
et.
Always disconnect the tool from
the power source when unattended,
performing any maintenance or repair, clearing a jam,
loading, unloading, or moving the tool to a new location.
Disconnect the tool from air source. Remove screw
and battery compartment cover. Insert two (2) new
batteries in the proper orientation. Do not mix old
and new batteries. Close cover. Replace screw.
Battery Replacement
Screw
Visit us at
chpower.com
