Rev: Jan 2018
8 of 18
®
BEAST Electric Pressure Washers
Step 3
Attach the L-shape coupler end of the extension hose (F) into the
water outlet as shown in Figure below. Fasten tightly to avoid
leakage.
Step 4
Attach the straight coupler end of the extension hose into the hose
reel inlet as shown in Figure below. Fasten tightly to avoid
leakage.
Step 2
Attach the Zinc Connect or Quick Connect Inlet coupling to water
supply inlet on pressure washer as shown in Figure below.
On some models the coupling or quick connect may be installed at
the factory for your convenience.
Step 6
Attach the soap/detergent bracket. Bottle, siphon hose, as shown
in the Figure below.
PREPARATION & ASSEMBLY - Model P1750B, P1750B-CAN, P1800B, P1800B-BB, P1800B-CAN, P2000B-BB
Step 7
Attach High Pressure Hose to Gun as shown in Figure below.
Fasten tightly with 17mm wrench to avoid leakage.
Step 8
Attach foot bracket as shown in Figure below.
Step 5
Attach the gun/wand holder as shown in the figure below.
Assembly Time: 5 minutes
Tools Required: 17mm or Adjustable Wrench
Note: 17mm wrench (Part L pg. 3) is provided in hardware bag.
Surface Preparation
Before starting any cleaning task, it is important to inspect the area
for objects which could create a hazard.
Remove any objects from the work area which could be tripped
over, such as toys or outdoor furniture.
Step 1
Remove or peel off blue protective film on the front of the pressure
washer and on the wands (if applicable). Also, remove any bubble
wrap. Discard blue protective film and bubble wrap.
For Operating Instructions, proceed to page 9.
