12
Fig.9
WARNING: DO NOT OBSTRUCT THE PRI-
MARY AIR SUPPLY TO THE SPIN VALVE AT
THE FRONT OF THE STOVE.
PLUMBING
(Fitting Optional DHW Boiler)
A stainless steel saddle boiler is available as an
optional extra. Fit boiler as follows:
1.
Open fire door.
2.
Remove fire bars.
3.
If the stove has already been in service
thoroughly clean out the combustion chamber.
4.
Remove side bricks.
5.
Remove back brick.
6.
Remove top baffle plate.
7.
Punch out the two boiler tapping blanks on
the back plate from the outside using a hammer
and dolly.
Fig.11
DOMESTIC HOT WATER SYSTEM
(DHW MODEL ONLY)
The DHW Model must be connected to a gravity
system. Care should be taken to ensure that the
domestic hot water installation is correctly installed
and that it complies with all relevant codes of prac-
tice. If this appliances is being connected to an exist-
ing system, it is strongly recommended to check the
following:
(a) That the system is sound.
(b) That the pipe work is adequately insulated.
(c) Are there any modifications necessary to
make the domestic hot water system more
efficient.
8”
8”
8”
10”
8.
Insert boiler through the fire door.
9.
Screw the two 28mm (1”) flange nuts over
the boiler connections. (Do not over tighten
flange nuts).
10. Replace side bricks.
11. Replace fire bars. (See Fig.11)
WATER PIPE LOCATIONS
Water connections 25mm (1”) B.S.P (See Fig. 10)
Fig.10
