22- ENG
• Merchandise sold by
STANLEY FATMAX
®
which has been manufactured by and
identified as the product of another company, such as gasoline engines. The product
manufacturer’s warranty, if any, will apply.
•
ANY INCIDENTAL, INDIRECT OR CONSEQUENTIAL LOSS, DAMAGE,
OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE OR
MALFUNCTION OF THE PRODUCT IS NOT COVERED BY THIS WARRANTY.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
•
IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR
FROM THE DATE OF ORIGINAL PURCHASE.
Some states do not allow
limitations on how long an implied warranty lasts, so the above limitations may not
apply to you.
TROUBLE SHOOTING GUIDE
OPERATIONAL
ISSUE
POSSIBLE CAUSE
SOLUTION
Engine will not
start (see
Engine
Owner’s
Manual
l for
further engine
troubleshooting)
No fuel.
Add fresh fuel.
Pressure builds up after
two pulls on the recoil
starter or after initial use
Squeeze gun trigger to
relieve pres sure
Choke lever in the "No
Choke" position
Move choke to the "Choke" po si tion
Spark plug wire
not attached.
Attach spark plug wire.
Engine switch in
OFF po si tion
Place engine switch in ON position
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat
for a long period of time
Move choke to the "No
Choke" po si tion
No or low
pressure
(initial use)
Spray wand not in
high pressure
See
How to Use Spray
Wand
instructions in the
Operation
Section
Low water supply
Water supply must be at
least 5 gpm @ 20 psi
Leak at high pressure
hose fitting
Repair leak. Apply sealant
tape if necessary
Nozzle obstructed
See
Nozzle Cleaning
instructions
in the
Maintenance
section
Water filter screen clogged Remove and clean filter. See
Cleaning Water Inlet Filter
paragraph in the
Maintenance
section for the correct procedure
