42
ENGLISh
Installing and Removing the Battery Packs
(Fig. I)
DANGER:
MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLING BATTERIES.
This mower is designed to operate on two battery packs of
equal capacity. The mower will not operate on a single battery
pack, and if using different capacity battery packs, the smaller
capacity battery pack, when depleted, will cause the unit to turn
off and the LED in front of the closed battery port cover to blink.
Unit will also turn off and the LED will blink if the battery packs
reach a high temperature limit, which can be caused by cutting
heavy grass. If this occurs, allow the battery packs to cool and
then resume cutting with the deck set higher.
NOTE:
For best results, make sure the battery packs
23
are
fully charged.
To Install the Battery Packs
1. Lift and hold the battery port cover
7
up to expose the
battery ports
24
.
2. Slide a battery pack into the battery port until an audible
click is heard. Repeat for the second battery
READ THIS INSTRUCTION MANUAL BEFORE
OPERATING YOUR MOWER
Refer to Figure A at the beginning of this manual for a complete
list of components. Save this manual for future reference.
DANGER:
Sharp moving blade
. Do not operate the
mower in mulching mode if the rear door and side
discharge door are not closed under spring tension as
serious injury could result. Take your mower to the nearest
service center for repair.
DANGER:
Do not operate mower unless handle is locked
into position.
DANGER: Sharp moving blade.
Never operate the
mower in bagging mode unless the bag lugs on the grass
collection bag are seated properly on the mower and the
rear discharge door rests firmly against the top of the grass
collection bag as serious injury could result.
WARNING:
Let the mower work at its own pace. Do
not overload.
Proper hand position requires both hands grasping the main
handle
4
and bail handle
5
together when not in self‑propel
mode; and both hands grasping the main handle, bail handle,
and self drive bail handle
14
together when in self‑propel
mode.
Proper Hand Position (Fig. K)
WARNING:
To reduce the risk of serious personal injury,
ALWAYS
use proper hand position as shown.
WARNING:
To reduce the risk of serious personal
injury,
ALWAYS
hold securely in anticipation of a
sudden reaction.
Starting Mower (Fig. I–K)
DANGER:
Sharp moving blade. Never attempt to
override the operation of the switch box and safety
key system as serious injury could result.
NOTE:
Mower is operational when battery packs and safety key
are installed.
1. Install battery packs
23
into mower as described in
INSTALLING AND REMOVING THE BATTERY PACKS.
2. Insert safety key
3
into the ON‑OFF switch box
1
until it is
fully seated inside housing. The mower is now operational.
3. Your mower is equipped with a special ON‑OFF switch
box
1
. To operate the mower, push and hold the ON‑OFF
button
2
on the ON‑OFF switch box
1
, then pull the bail
handle
6
to the main handle
4
.
NOTE:
Once the mower starts you can release
the ON‑OFF button, but you must continue to hold the bail
handle to the main handle for the mower to run.
4. To turn the mower OFF, release the bail handle
6
.
WARNING:
Never attempt to lock a switch or bail handle
in the ON position.
NOTE:
Once the bail handle has returned to the original position
it will activate the “Automatic Braking Mechanism”. The motor is
braked and the mower blade will stop rotating in three seconds
Safety Key (Fig. J)
DANGER:
Sharp moving blade.
In order to prevent
accidental start-up or unauthorized use of your
cordless mower, a removable safety key
3
has been
incorporated into the design of your mower. The mower
will be completely disabled when the safety key has been
removed from the mower.
NOTE:
The safety key has a tether rope to allow for storage
on a nail, out of the reach of children. Do not tether safety key
to mower.
DANGER: Rotating blades can cause serious injury.
To prevent serious injury, turn unit off and remove safety
key and battery packs when unattended, or when
charging, cleaning, servicing, transporting, lifting, or
storing mower.
NOTE:
Ensure the battery packs are fully seated and fully latched
into position before starting mower.
3. Close the battery port cover. Ensure the cover is fully closed
before starting mower.
To Remove the Battery Packs
1. Lift and hold the battery port cover up to expose the
battery ports.
2. Depress the battery release buttons
22
on the battery
packs and pull the battery packs out of tool.
Summary of Contents for FATMAX SFMCMW2651
