5
ENGLISH
(Original instructions)
Charger LED Modes
Charging
Fully Charged
Hot/Cold Pack Delay
Note:
The compatible charger(s) will not charge a faulty
battery pack. The charger will indicate a faulty battery pack by
refusing to light.
Note:
This could also mean a problem with a charger. If the
charger indicates a problem, take the charger and battery
pack to be tested at an authorized service centre.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefinitely. The charger will keep the battery
pack fresh and fully charged.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too cold,
it automatically starts a Hot/Cold Pack Delay, suspending
charging until the battery has reached an appropriate
temperature. The charger then automatically switches to the
pack charging mode. This feature ensures maximum battery
life.
Maintenance
Your Stanley Fat Max tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning!
Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
u
Regularly clean the ventilation slots in your tool and
charger using a soft brush or dry cloth.
u
Do not use any abrasive or solvent-based cleaner.
Protecting the environment
Z
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Use
Warning!
Let the tool work at its own pace. Do not overload.
Warning!
Before drilling into walls, floors or ceilings, check for
the location of wiring and pipes.
USB Charging Port
The charger (1) is equipped with one USB Type A output port
(2).
The port delivers 2 amps current. The port is not intended for
any uses other than supplying power/charging small USB
electronics such as a phone, tablet, MP3 player, etc.
Note:
The current delivered to device is dependent upon user
device and user's chosen cable. A USB cable is not supplied.
u
Plug the USB-A end of the cable into the SFMCB24 and
the other end of the cable into a compatible device.
Charging will start automatically.
u
To turn OFF, disconnect USB device.
Charging the battery
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that were
easily done before.
The battery may become warm while charging; this is normal
and does not indicate a problem.
W
arning!
Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell
temperature warms up or cools down.
Note:
To ensure maximum performance and life of lithium-ion
battery packs, charge the battery pack fully before first
use.
u
Plug the charger (1) into an appropriate outlet before
inserting battery pack (3).
u
Connect the charger (1) and battery pack (3) making sure
the battery pack is fully seated.
u
The charging green light will blink continuously indicating
that the charging process has started.
u
The completion of charge will be indicated by the green
charging light remaining ON continuously. The battery
pack (3) is fully charged and may be removed and used at
this time or left in the charger (1).
u
Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
