6
7
CYLINDER CARE
Gas Inlet Connection
Gas inlet connection is a 3/8 internal flare located at the rear of
heater, suitable for connection to the hose assembly supplied with
heater.
Connecting to Cylinder
1. Ensure cylinder is in its full off position.
2. Check for any damage to either the cylinder or the hose. NEVER
attempt to use damaged equipment.
3. When connecting the hose to the cylinder tighten the nut to a
positive stop by hand or spanner.
4. Open cylinder valve fully. If a leak can be heard at either end of
the hose turn cylinder off and tighten joint. Wait five minutes
before re-testing and use a soapy water solution to check
the joint. If bubbles appear the connection will need to be re-
tightened.
Clothing or other flammable materials should not be placed on or near
the heater. Direct contact with these metal surfaces should be avoided
in order to prevent burns or clothing ignition.
Heater Specifications
Heater specifications can be found on the data label.
IMPORTANT NOTE
THE GAS CYLINDER MUST ALWAYS BE LOCATED
AT THE REAR OF THE HEATER. NEVER DIRECT AIR
FLOW TOWARDS THE CYLINDER.
Screw the coupling nut of regulator into the cylinder valve outlet.
(Cylinder not included)
POL CYLINDER CONNECTION DEVICE
Type of Gas
Propane
Consumption
38 MJ/h
Operating Pressure
150 kPa
Injector Size
0.625 mm
