Stanley 7634802430, Instruction Manual

Page: 7 / 25

6
For assistance with your product, visit our website at www.stanleyledlighting.com or call, email
or write our Customer Care Center at 1-(877) 714-8669, Barbados at 18443395176, Columbia
at 018005185201, Dominican Republic at 18002039606, Trinidad and Tobago at 18002031746.
LutecUSA 149-B Houston Road, Troutman, NC 28166
Email: Service@Lutec.net
Be sure to include the product model number, name, address, phone and email along with a
short explanation best describing the assistance needed.
The extension lock is
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
• Light will not illuminate. • The power is off.
•
• The switch is off.
• There is poor connection between
the power cord and outlet.
• Make sure the switch is on.
• Make sure the connection is OK.
• Make sure the power supply is on.
• The screw beside the extension
lock is loose.
Phillips screwdriver (not included).
OPERATING INSTRUCTIONS
Pivoting the Head/Lamps - Figures G, H, I
1.The housing allows the light heads [Item 3] to be rotated to desired position within the
165 degrees of rotation and 90 degree pivot range.
2.If the light heads are either too loose or tight after adjustment, tighten the screw in the
shaft with the wrench.
3.Store the wrench as shown in figure I.
Extending the Tripod Legs - Figure A,B,C
1.Release the Tripod Extension Lock [Item 1] to extend the legs outward.
2.Secure the Tripod Extension Lock [Item 1].
Power Cord Routing - Figure J
1.Uncoil the power cord [Item 4] and route through the slot at the bottom of the base,
as shown.
2.Plug cord into properly grounded outlet. Refer to
Grounding Instructions .
Adjusting the Tripod Height - Figure D,E
1.Release the Top Extension Lock [Item 2] to enable the light heads to be raised to
desired height.
2.Secure the Top Extension Lock to maintain desired height.
7
WARNING:
Tipping Hazard. To reduce the risk of serious injury, always make sure
the legs are locked position before using the tripod light.
Tripod Placement - Figure F
1.Place tripod on a firm, stable, flat and secure surface.
WARNING:
Tipping Hazard. Ensure tripod is used on flat surface – maximum
slope 8°
Switch Operation – Figure K
1.To turn the light on, press the on/off button [Item 5], as shown.
2.To turn the light off, press the button again.