Page 16
Radar Installation Manual
2.7
CHART PLOTTER CONNECTIONS AND SET UP
The following instructions refer to Dome Antennas; refer to Open Array for connections.
2.7.0 CP180 & CP180i Connections
PWR & ACC 1 Cable
A switch MUST be connected
to turn the Radar On or Off
Radar
Switch
Battery
Battery Switch
RADAR CABLE
WIRE COL. FUNCTION
BLACK
DATA GROUND
ORANGE
DATA OUT+
YELLOW
DATA OUT-
BROWN
DATA IN+
RED
DATA IN-
GREEN
POWER ON/OFF SWITCH
BLUE
POWER ON/OFF SWITCH
BLACK
RADAR BATTERY GROUND
WHITE
RADAR BATTERY POSITIVE
PLOTTER CABLE
WIRE C L R FUNCTION
O O
GREEN
GND
No connection AUX OUT+
BROWN
(TX+)
BLUE
INPUT+ (RX+)
BLACK
POWER- /GND
RED
POWER+
(Port 1)
(Port 1)
Breaker panel
Figure 2.7.0 - CP180 & CP180i Connections
Port Setup
When an optional Radar Antenna is connected, Port 1 of the NMEA In/Out Communication
Setup menu must be changed to RADAR as shown below for communications.
1. From the Chart page, press
[MENU]
. Move the ShuttlePoint knob to highlight
SETUP
MENU
and press
[ENT]
.
