Standard Horizon QUANTUM Series GX3500S, Owner'S Manual

Page: 33 / 100

Page 33 GX3500S
10.16.1 Communication
1. Press the [ F
] key followed by the [
5
(
IC
)] key, the mode
is changed to “INTERCOM” mode.
2. If your GX3500S is equipped two RAM+ Mic’s (or
VH-310 Handset), select the companion you wish to
communicate (RAM1, RAM2, or ALL) with the CHANNEL selector knob,
then press the [ ENT
] key.
3. When the “INTERCOM” operation is
activated, “ Intercom ” is displayed on
the GX3500S , and “ IC ” is displayed on
the RAM+ Mic (or VH-310 Handset).
4. Press the PTT switch. “
Talk
” will be
shown on the display.
NOTE : A warning beep will be emitted
when the GX3500S microphone’s PTT
switch is pressed while the RAM+ Mic’s (or VH-310 Handset’s) PTT switch
is pressed.
5. Speak slowly and clearly into the microphone, hold the microphone about
1/2 inch away from your mouth.
6. When finished, release the PTT switch.
7. To exit the “INTERCOM” mode and return to radio operation mode, press
the [ F
] key followed by the [
5
(
IC
)] key again.
10.16.2 Calling
Press and hold the [ 5
(
IC
)] key for 1 second when the “INTERCOM” operation is
activated, a calling beep is emitted twice from the transceiver speaker.
NOTE
When both RAM+ microphones (or VH-310 Hand-
sets) are set to intercom mode, the GX3500S will
be temporarily disabled until the remote mics exit
the intercom mode.
(RAM+ Mic’s
PTT switch is pressed)
(
GX3500S ’s PTT switch is pressed)