Standard Horizon ECLIPSE, Owner'S Manual

Page: 41 / 98

39
10.3.2 Receiving an All Ships Call
1. When an all ships call is received, an emergency alarm sounds.
The display will show the MMSI (or name) of the vessel transmitting the all
ships call.
2. Press any key on the radio to stop the alarm.
3. To immediately switch to requested channel, press
the [ ACCEPT ] soft key.
If a key is not pressed for thirty seconds (by
default; refer to the section “ 10.3.8 Auto Channel
Switching Time ”) after an all ships call is received,
the transceiver will automatically switch to the
requested channel for you to monitor communica-
tions.
RX ALL SHIPS
YAESU
CATEG: SAFETY
CH: 08
SINCE: 00:05
ACCEPT QUIT PAUSE
ALL SHIPS PAUSE
QUIT RESUME
BUSY
USA
25W
08
4. Press the [ PAUSE ] soft key to suspend the
acknowledgement.
Press the [ RESUME ] soft key to resume the
acknowledgement.
5. If you want the radio to stay on the channel you were on before receiving
the all ships call, press the [ QUIT ] soft key.
6. Press the [▲] or [▼] key to scroll the screen and see
the MMSI (or name) of the calling vessel, category
of the call and requested operating channel.
RX ALL SHIPS
YAESU
CATEG: SAFETY
CH: 08
SINCE: 00:08
ABLE QUIT UNABLE
7. Press the [ QUIT ] soft key to display the operating
channel number of the requested channel.
8. Press the PTT switch on the microphone and talk to the calling vessel.
10.3.3 Setting up the All Ships Call Ringer
The transceiver has the capability to turn off the all ships call ringer.
1. [
]

“ SETUP ”

“ DSC SETUP ”

“ DSC BEEP ”
2. Select “ ALL SHIPS ” with the [▲] or [▼] key, then
press the [
SELECT
] soft key.
BACK SELECT
DSC BEEP
INDIVIDUAL
GROUP
ALL SHIPS
POS REQUEST
ON
ON
ON
OFF