STEP 6:
Make sure that the threaded holes in the
FOOTBAR(5)
are facing toward the end of the
AeroPilates Premier Studio
as shown in the illustration. Insert the
FOOTBAR(5)
into the mounting holes
located in the
FRONT COVER(3)
and
FRONT FRAME(1).
Insert the
FOOTBAR(5)
all the way to the bottom
and lock it in place with the
LOCKING KNOBS(26).
NOTE:
You can choose to insert the
CARDIO REBOUNDER(50)
into the
FRONT FRAME(1)
and lock in
position with the
LOCKING KNOBS(26).
Refer to the inset drawing.
9
ASSEMBLY INSTRUCTIONS
STEP 7:
Insert the
PULLEY RISERS(25)
into the mounting holes in the
REAR COVER(4)
and
REAR
FRAME(2).
Insert the
PULLEY RISERS(25)
all the way to the bottom, align the threaded holes in the
PULLEY RISERS(25)
with the holes in the
REAR FRAME(2),
and lock the
PULLEY RISERS(25)
in position
with the
LOCKING KNOBS(26).
STEP 5:
Remove the paper covering from the foam tape inside the
FRONT COVER(3)
and
REAR COVER(4).
Place the
FRONT COVER(3)
over the
FRONT FRAME(1).
Place the
REAR COVER(4)
over the
REAR
FRAME(2).
Press the covers securely in place.
STEP 8:
Refer to the detail drawing above showing an enlarged view of the left
PULLEY RISER(25)
and
the
LEFT PULLEY HOOK(23).
With the pulley facing down, insert the
LEFT PULLEY HOOK(23)
into the
left
PULLEY RISER(25)
from the inside as shown. Swing the pulley forward as shown and the
LEFT PULLEY
HOOK(23)
will be in position for use. Use the same procedure to install the
RIGHT PULLEY HOOK(24)
on
the right
PULLEY RISER(25).
