ASSEMBLY INSTRUCTIONS
8
STEP 4
Remove the paper covering from the foam tape inside the
FRONT COVER(7)
and
REAR COVER(8).
Place the
FRONT COVER(7)
over the end of the
FRONT FRAME(1).
Place the
REAR COVER(8)
over
the end of the
REAR FRAME(2).
Press the covers securely in place.
NOTE:
The securing
SCREWS(M6x1x35mm)(42)
for the
PULLEY SET(26)
on each side may need
to be loosened to allow the
REAR COVER(8)
to fit securely over the frame. Refer to the inset
illustration. When retightening the screws for the
PULLEY SETS(26)
do not over tighten. The
PULLEY SETS(26)
should swivel freely.
STEP 5
Insert the
FOAM PAD ASSEMBLIES(21)
into the holes located on the
CARRIAGE(12).
Summary of Contents for AeroPilates Home Studio
Page 14: ...PRODUCT PARTS DRAWING 14 FRONT BACK ...
Page 18: ...NOTES 18 ...