Stamina 55-1538, Owner'S Manual

Page: 8 / 18

ASSEMBLY INSTRUCTIONS
8
STEP 5
Attach the
FOOTREST(8)
onto the
HEIGHT ADJUSTMENT BEAM(6)
with the
ADJUSTMENT
KNOB(9).
NOTE:
STEP 6:
Insert the
PAD TUBE(10)
through the hole on the
HEIGHT ADJUSTMENT BEAM(6)
and
secure with
HEX BOLT(M6 x 47mm)(40), NYLOCK NUT(M6)(42),
and
WASHERS(M6)(45).
Place
a
HEEL HOLDER BRACKET(11)
onto a
HEEL HOLDER(12),
then slide them onto
PAD TUBE(10)
together. Slide another set of
HEEL HOLDER BRACKET(11)
and
HEEL HOLDER(12)
over the other
end of the
PAD TUBE(10).
STEP 7:
Attach the
ADJUSTABLE INSTEP FRAME(7)
to the
HEIGHT ADJUSTMENT BEAM(6)
by pulling the
SMALL SPRING PIN(15)
and sliding the
ADJUSTABLE INSTEP FRAME(7)
completely
into the
HEIGHT ADJUSTMENT BEAM(6).
Place a
WASHER(M6)(45)
onto the
HEX BOLT
(M6 x 47mm)(40),
then insert the bolt the halfway through the square tube on the
HEIGHT ADJUSTMENT
BEAM(6),
slide the bolt through the ring at the bottom of the
SPRING(13),
slide the bolt through the
square tube and secure with
NYLOCK NUT(M6)(42)
and
WASHER(M6)(45).
Press the
SQUARE
PLUG(35)
into the
HEIGHT ADJUSTMENT BEAM(6).
Install a
HEEL HOLDER BRACKET(11)
and
HEEL HOLDER(12)
onto both sides of the
ADJUSTABLE INSTEP FRAME(7).
The four adjustment holes in the
FOOTREST(8)
allow the
FOOTREST(8)
to be attached in four
different positions. Start with one of the center positions and adjust if necessary. Use the outer
position if users are taller than average. Use the inner position if users are shorter than average.