ASSEMBLY INSTRUCTIONS
7
B
A
C
STEP 3
Slide the bottom of the two
PIVOT ARMS(91)
into the brackets located at each side of the
MAIN FRAME
(92).
Align the desired hole on the arm with the peg on the bracket, then insert the peg into the hole to lock
the
PIVOT ARMS(91)
in position.
Secure the PIVOT ARMS(91) with the SECURING KNOBS
(3/8"-16 x 1/2")
(93) on the inner side of the brackets.
Use the lowest holes in the
PIVOT ARMS(91)
until you become familiar with the
Elite
Inversion System
Both
PIVOT ARMS(91)
must be adjusted to the same hole. Trying to adjust the
PIVOT
ARMS(91)
to different positions could cause damage to the machine, and injury to the user.
1.
2.
STEP 4
Attach the
MAIN FRAME(92)
onto the
REAR FRAMES(2, 3)
by sliding the slots in the ends of the two
PIVOT ARMS(91)
into the slots on the
REAR FRAMES(2, 3)
and secure with the
SHAFT CLIPS
(43, 44)
.
CAUTION:
PIVOT ARM ADJUSTMENT:
There are three adjustment holes on the
PIVOT ARMS(91)
allowing you to position the
MAIN FRAME(92)
at three different heights. The lowest hole will allow the least amount of inversion angle. The top hole will
allow the greatest amount of inversion angle.
