ASSEMBLY INSTRUCTIONS
9
STEP 7:
Install the
HEIGHT ADJUSTMENT BEAM(12)
into
MAIN FRAME(4)
by pulling the
SPRING
PIN(22)
on the
MAIN FRAME(4)
and inserting the
HEIGHT ADJUSTMENT BEAM(12)
as shown. For added
safety, thread the
SECURING KNOB(23)
into the back side of the
MAIN FRAME(4).
WARNING:
Do not use the
Assisted Inversion Pro
until you have verified your height setting. Failure to
use the proper height setting can result in difficulty recovering from the decline position. See
HEIGHT ADJUSTMENT
instructions on page 11.
1.
2.
A.
C.
B.
BUCKLE
3.
STEP 8:
Attach the end of the
NYLON STRAP(31)
to the hook on the back of the
MAIN FRAME(4);
attach the end of the
BUCKLE STRAP(32)
to the hook on the
FRONT FRAME(1),
as shown in
Illustration 2. The
NYLON STRAP(31)
must be secured to the
MAIN FRAME(4)
and the
BUCKLE
STRAP(32)
must be secured to the
FRONT FRAME(1).
WARNING:
DO NOT ALLOW table to invert past vertical. Table inverting past vertical may result in table
contacting frame, damage to table and serious injury to user due to fall hazard. Prior to each
use, make sure nylon and buckle straps are securely attached, as instructed in Steps 8 and
9. Adjust straps to desired angle of inversion, making sure that Main Frame does not strike
Front Frame at any time during use, as shown in illustrations on page 12.
STEP 9:
Attach the
NYLON STRAP(31)
to the
BUCKLE STRAP(32)
by inserting the end of the
NYLON
STRAP(31)
through the bottom of the
BUCKLE,
as shown in Illustration 3 (Steps A, B and C). The
NYLON STRAP(31)
must be securely attached to the
BUCKLE STRAP(32)
through the
BUCKLE.
The
NYLON STRAP(31)
and
BUCKLE STRAP(32)
are used to control the decline angle of the
MAIN
FRAME(4).
Check the decline angle before using the
Assisted Inversion Pro.
To increase the decline,
lengthen the straps. To decrease the decline, shorten the straps.
BUCKLE
