10
ASSEMBLY INSTRUCTIONS
Shaft
Shaft
Nylon Bed
STEP 10
Attach the
LINKAGES(7)
to the
LEFT
and
RIGHT PIVOT ARMS(5, 6)
with
HEX BOLTS(M8x1.25x25mm)
(46), WASHERS(M8)(51),
and
NYLOCK NUT(M8x1.25)(49). DO NOT OVER TIGHTEN THE BOLTS.
STEP 11
Slide the
LEFT
and
RIGHT PROTECTIVE COVERS(26, 27)
onto each side of the
BASE ASSEMBLY,
and
pull the covers down until the bottom of the covers are slightly lower than the
FOLDING LINKAGES(3).
Make sure the
SHAFTS
on the
FRONT FRAME(1)
poke out through the hole on the
PROTECTIVE
COVERS(26, 27).
Secure the
PROTECTIVE COVERS(26, 27)
to the
FOLDING LINKAGES(3)
with the
SECURING STRAPS
on the covers.
NOTE:
STEP 12
Attach the
LEFT
and
RIGHT
HANDRAIL ASSEMBLYS(8, 9)
to the
SHAFTS
on both sides of the
FRONT
FRAME(1)
and then connect to the
LINKAGES(7)
with the
LOCKING KNOBS(11).
STEP 13
Verify that the handlebars function correctly before using the
Assisted Inversion Pro.
Move the Nylon Bed
on the
MAIN FRAME(4)
backward toward the inverted position. The
HANDRAILS(10)
must move forward
as the
MAIN FRAME(4)
moves backward. If the
HANDRAILS(10)
do not move forward check
ASSEMBLY
STEPS 2, 10, 11, and 12.
When the
PROTECTIVE COVERS(26, 27)
are assembled correctly the
FOLDING LINKAGES(3)
should not be visible.
