10
SET UP INSTRUCTIONS
Place the
TOTAL BODY RECUMBENT BIKE
in the area where it will be used. It is recommended that the
TOTAL BODY RECUMBENT BIKE
be placed on an equipment mat. The
TOTAL BODY RECUMBENT
BIKE
is approximately 49 5/8" long x 23 5/8" wide x 48 5/8" tall. (These dimensions may vary up to one
inch.) An area 4 feet wide x 6 feet long is required for safe operation of the
TOTAL BODY RECUMBENT
BIKE.
Make sure that adequate space is available for access to and passage around the
TOTAL BODY
RECUMBENT BIKE.
Place the
TOTAL BODY RECUMBENT BIKE
on a flat surface and equipment mat to set it on
the floor without rocking. Adjust the
STAND(65)
under the
REAR FRAME(2)
to get more
support for the base of the
TOTAL BODY RECUMBENT BIKE.
LEVELING:
FUNCTION INSPECTION:
Visually inspect the
TOTAL BODY RECUMBENT BIKE
to verify that assembly is as shown in the above
illustration. Check the function of the
TOTAL BODY RECUMBENT BIKE.
Turn the pedal and then handlebar
slowly through one complete revolution to verify that the drive train functions properly. Adjust the
TENSION
KNOB(21)
and verify that it functions properly.
Equipment Mat
MOVING:
Locate and read the
WARNING LABEL(108)
on the
TOTAL BODY RECUMBENT BIKE.
Make
sure that all users read the
WARNING LABEL(108).
CAUTION:
The
TOTAL BODY RECUMBENT BIKE
has a pair of
WHEELS(76)
on the
FRONT
STABILIZER(8).
Lift up from
REAR STABILIZER(9)
to move the
TOTAL BODY RECUMBENT
BIKE.
Loosen the
NUT(M8x1.25)
until they touch the
LEVELING STAND(65)
. Adjust the
LEVELING
STAND(65)
for leveling. Tighten the
NUT
(M8x1.25)
securely against the
REAR FRAME(2)
to lock the stand in position.
Nut
Summary of Contents for 15-9100B
Page 16: ...16 PRODUCT PARTS DRAWING FRONT BACK ...
Page 20: ...NOTES 20 ...
Page 21: ...NOTES 21 ...
