STORAGE
1.
2.
3.
4.
To store the
5125u Magnetic Bike
simply keep it in a clean dry place.
The
5125u Magnetic Bike
is approximately 33 1/4" long x 19 1/8" wide x 54" tall. These dimensions may
vary. Please measure your
5125u Magnetic Bike
if exact dimensions are needed.
Lift the
5125u Magnetic Bike
from the
REAR STABILIZER(3)
and
HANDLEBAR(5)
to move.
To avoid damage to the electronics, remove the batteries before storing the
5125u Magnetic Bike
for
one year or more.
MAINTENANCE
15
The safety and integrity designed into the
5125u Magnetic Bike
can only be maintained when the
5125u
Magnetic Bike
is regularly examined for damage and wear. Special attention should be given to the following:
Adjust the
TENSION KNOB(25)
and verify that the Magnetic System provides tension. The Magnetic
System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise.
Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
Do not step on any portion of the plastic cover when getting on or off the Bike. This can cause the plastic
cover to crack.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the
5125u Magnetic Bike
removed
from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the
5125u Magnetic Bike.
Keep your
5125u Magnetic Bike
clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
8.
HOW TO INSTALL AND REPLACE BATTERY:
AA Batteries
COMPUTER INSTRUCTIONS
1.
2.
Do not mix a new battery with an old battery.
Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
Rechargeable batteries are not recommended.
1.
2.
3.
NOTE:
Open the Battery Door on the back of the meter.
The meter operates with two AA batteries, two batteries included.
Refer to the illustration to install or replace the batteries.
OPERATION DESCRIPTIONS
To stop a running program, stop pedaling for 4 seconds to switch into
"STOP"
mode. In this mode, you
can move the pedals again to continue to run the current program or, you can press the
SET
button to
select a new program. The functional values of
DISTANCE
and
CALORIES
will continue to accumulate.
When you complete a program, you can stop pedaling and press
SET
button to select a new program.
The functional values of
DISTANCE
and
CALORIES
will continue to accumulate. This will allow you to
run several programs and still know the total
DISTANCE
and
CALORIES
during the workout.
If you want to restart with a new program, press and hold the
MODE
button down for two seconds to
reset all of the function values to zero. Press
SET
button to select a new program.
The computer will shut off automatically after 3 minutes of inactivity and all function values will be reset
to zero.
1.
2.
3.
4.
Summary of Contents for 15-5125
Page 18: ...PRODUCT PARTS DRAWING BACK FRONT 18...
Page 22: ...22 NOTES...
