ASSEMBLY INSTRUCTIONS
STEP 4:
Insert the
LEFT HANDLEBAR(12)
into the
PIVOTING ARM(1)
and secure with
HEX
BOLTS(M6x1x35mm)(18), ARC WASHERS(M6)(17),
and
NYLOCK NUTS(M6x1)(16).
The
HEX BOLTS
(M6x1x35mm)(18)
must fit inside the hex-shaped holes in the
PIVOTING ARM(1)
to properly secure the
LEFT HANDLEBAR(12).
Repeat on the right side.
STEP 5
NOTE:
The
RIGHT PEDAL(113)
has an
R
stamped on the end of the pedal shaft. The
RIGHT
PEDAL(113)
has right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(51)
has an
L
stamped on the end of the pedal shaft. The
LEFT PEDAL(51)
has left hand threads
and is tightened by turning counterclockwise.
Thread the
RIGHT PEDAL(113)
into the
RIGHT PIVOTING ARM(2).
Tighten the pedal securely. The
shoulder of the
PEDALS(51, 113)
should be in contact with the
PIVOTING ARMS(1, 2)
when securely
tightened. Do the same to attach the
LEFT PEDAL(51)
to the
LEFT PIVOTING ARM(1).
STEP 6:
Install two AAA batteries into the
METER(23),
the batteries are not included. See page 15 for
detailed battery installation instructions. Plug the
CONNECTION WIRE(105)
into the
METER(23)
, and
push the excess wires back into the
UPRIGHT(5).
Slide the
METER(23)
onto the plate on the
UPRIGHT
(5).
Be careful not to damage the wires when attaching the
METER(23).
10
Shoulder
Summary of Contents for Active Aging EasyStep 40-0200
Page 2: ...EasyStep...
