5. Auto change mode
The LED PAR shows different colours depending on speed selection.
In this mode the LED PAR is used stand alone, the DMX output/input is
not used.
5.1 Mode setting
To enable the auto change mode, set the 4 pin DIP switch on the rear
panel of the LED PAR according to the this table:
SW4 SW3 SW2 SW1 Mode
X
0
0
0
auto change
0 = DIP switch is set to off.
1 = DIP switch is set to on.
X = see information below.
5.2 Speed setting
SW4 sets the speed source. Choose the speed source according this
table:
SW4 SW3 SW2 SW1 Mode
0
X
X
X
speed control by potentiometer
1
X
X
X
speed control by music
0 = DIP switch is set to off.
1 = DIP switch is set to on.
X = see information below.
5.3 Colour pattern setting
The colour modes may be set by the 10pin DIP switch on the rear panel of
the LED PAR according to the this table:
SW10 SW9 SW8 SW7 SW6 SW5 SW4 SW3 SW2 SW1 Colour pattern selection
0
0
0
0
0
0
0
0
0
0
compatible mode - old pattern style
0
0
0
0
0
0
0
0
0
1
100% colour change
0
0
0
0
0
0
0
0
1
0
100%, 50% colour change
0
0
0
0
0
0
0
0
1
1
100%, 75%, 50%, 25% colour change
0 = DIP switch is set to off.
1 = DIP switch is set to on.
If another colour pattern is set, always patterns “0000000011” is used.
