www.thomann.de
DJ Lase Pro 1000 RGB
11
Operation
Start the device
Perform the following steps to start the operation:
1. Verify that all required laser safety precautions have been taken. Make sure that there is no one in the
reach of the laser beam.
2.
Insert the safety key (7) and turn it to the “OFF” position.
3. If not already connected, connect the device to the mains (10).
4. Using the main switch (11), turn the device on. After a few seconds, the fan and the motors start to work.
The display shows the current operation mode. The device is now operational.
5.
Turn the safety key (7) to the “ON” position to turn the laser beam on.
Main menu
Press “FUNC” to activate the main menu and to select one of the operation modes.
When the display flashes, use the “UP” and “DOWN” buttons to change the displayed value. When the display
shows the desired value, press “ENTER”. To go back to the main menu without any changes, press “FUNC” or
wait for one minute.
All settings that were made previously are kept, even if you disconnect the device from the power supply.
Auto show mode
Press “FUNC” until the display shows “MODE: AUTO SHOW 1”. The device operates in stand-alone mode and
displays a pre-programmed show that can optionally be controlled by the built-in microphone. Using the “UP”
and “DOWN” buttons, you can now choose between the show types shown in the table below. Press “ENTER”
to confirm and to start the operation.
Display
Show type
AUTO SHOW 1
Automatic show type 1, characterized as “fast and hot”
AUTO SHOW 2
Automatic show type 2, characterized as “slow and soft”
MUSIC SHOW 1
Sound-controlled automatic show type 1, characterized as “fast and hot”
MUSIC SHOW 2
Sound-controlled automatic show type 2, characterized as “slow and soft”
Note that the laser will be turned off when you have selected a sound-controlled show but no sound is being
received by the microphone.
SD show mode
Press “FUNC” until the display shows “MODE: SD SHOW dir:”. If you have inserted an SD card in the slot (14)
that has show programs stored on it, you can now select a folder on the SD card using the “UP” and “DOWN”
buttons. When the name of the desired folder appears in the display, press “ENTER” to confirm.
You can now select, if the device should display a single ILDA show (from an *.ild file) or a pre-programmed
show (from a *.prg file). Using the “UP” and “DOWN” buttons, choose between “MODE: SD: PRG SHOW” or
“MODE: SD: ILD SHOW”, respectively, then press “ENTER” to confirm.
At this point, you can select the file to be used from the current folder. Press “UP” or “DOWN” until the name of
the desired file appears in the display, then press “ENTER” to confirm.
The device now starts to play back the show from the selected file in an endless loop.
DMX mode
Press “FUNC” until the display shows “MODE: DMX”, then press “ENTER”. You can now set the number of
the first DMX channel of the device (DMX address). Select a value between 1 and 512 using the “UP” and
“DOWN” buttons. Press “ENTER” to store the value and to start the operation in DMX mode.
Ensure that this channel number fits to the configuration of your DMX controller. Since the device uses 13
DMX channels, the highest usable DMX start address is 500.
Master/slave mode
Press “FUNC” until the display shows “MODE: SLAVE”. In this mode, the device exactly follows the operation
of the “master” it is connected to. Press “ENTER” to confirm and to start the operation.
