Symptom
Remedy
The unit does not work, no light, the fan does
not run
1. Check the power connection and main fuse.
2. Check the safety key switch.
No response to the DMX controller
1. If the display shows a flashing number, for example “001”, no DMX signal is
being received. Check the DMX connectors and cables to see if they are prop‐
erly linked.
2. If the display does not flash and there is no response, check the address set‐
tings and DMX polarity.
3. Try using another DMX controller.
4. Check whether the DMX cables run near or parallel to high-voltage cables
that may cause damage or interference to the DMX interface circuit.
No response to the remote control
1. Check to see that the unit is in operation mode ‘Remote Control’. The display
has to show
.
2. Try using the remote control at a different angle to the IR sensor on the front
panel of the device. If the device receives a signal from the remote control the
‘MUSIC’ lights up briefly.
3. Check the remote control battery.
Troubleshooting
showlaser
50
Summary of Contents for DJ Lase 150-R MK-III
