Technical Procedure
Page 6
620-8590 Rev. A
23. Ensure that the bottom nut located on the cable
is threaded all the way down then secure the
bottom end of the new brake cable into the new
cable bracket.
24. Use a 5mm allen key and a 10mm wrench to re-
move and replace the brake screw with the screw
supplied.
25. Set the resistance to Level 6 then thread a cable
fitting end onto the bottom of the cable and
connect it to the left side of the brake via the
screw installed in Step 24. Ensure that the brake
is pushed up against the flywheel while attach-
ing the fitting to the brake screw.
26. Using a 10mm wrench and a 5mm allen key,
tighten the M6 nut onto the screw replaced in
Step 24.
27. Install the supplied e-clip onto the new brake
screw.
28. Remove
ONE
of the screws securing the brake
assembly to the brake using a 6mm allen key,
then use a 10mm socket to install one of the
supplied hex head screws. DO NOT REMOVE ALL
THREE SCREWS AT THE SAME TIME.
29. Repeat Step 28 for the remaining two screws. All
three screws should be replaced.
