Mounting and Installation
40
147924 / 8146647300
2018-12-06·BA00·III·en·12
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Safety switch / load disconnect switch
Series 8146/5-V37, Series 8150/5-V37,
Series 8146/5-V11
7.3.2 Conductor Connection
Conductor connection to main terminal
• Strip the conductor.
• Insert the conductor into the main terminal and make sure that the conductor insulation
reaches right up to the terminal.
• Tighten the mounting scew with a tightening torque according to the specifications in
the "technical data".
Conductor connection to main terminal using an insertion prism
• Strip the conductor.
• Remove the protective foil from the insertion prism and glue the insertion prism in the
main terminal.
• Insert the conductor into the main terminal and make sure that the conductor insulation
reaches right up to the terminal.
• Tighten the mounting scew with a tightening torque according to the specifications in
the "technical data".
7.3.3 Cable Lug Connection
For permissible conductor cross-sections refer to "Technical Data".
WARNING
Risk of electric shock due to conducting metal parts located outside the
switch!
Non-compliance can result in severe or fatal injuries.
• Only operate the switch with installed protection against accidental
contact!
WARNING
Risk of electric shock due to conducting metal parts if openings are not
completely sealed.
Non-compliance can result in severe or fatal injuries.
• Avoid contact with conducting metal parts even if protection
against accidental contact is installed.
• To obtain the degree of protection IP20, mount a suitable covering
in addition to the protection against accidental contact.
Summary of Contents for Reihe 8146/5-V11
Page 93: ......
