Operating Instructions Scanner IDM
Safety Advice
R. STAHL HMI Systems GmbH / OI_Scanner_IDM_en_V_01_00_04.docx / 29.01.2016
Page 13 of 36
9
Safety Advice
This chapter is a summary of the key safety measures. The
summary is supplementary to existing rules which staff also have to
study.
The safety of persons and equipment in hazardous areas depends
on compliance with all relevant safety regulations. Thus, the
installation and maintenance staff carry a particular responsibility,
requiring precise knowledge of the applicable regulations and
conditions. requiring precise knowledge of the applicable regulations
and conditions.
The notes listed below in section 9.1 must be heeded to avoid injury
and damage to equipment!
9.1
Installation and operation
Please note the following when installing and operating the device:
•
Electrical plants are subject to certain regulations concerning installation and operation
(e.g. RL 99/92/EG, RL 94/9EG, or the national rules such as IEC/EN 60 079-14 and
VDE 0100).
•
In the hazardous area it is the operator's responsibility to carry out any repair and
maintenance in compliance with applicable rules.
•
The handheld scanners and the IDM160-BT-BaseBT-Z1 base loading station may be
installed and operated in zones 1, 2, 21 and 22.
•
The devices must only be operated when they are fully assembled.
•
Users must not open the devices.
•
If the enclosure is in any way damaged the device must be removed from the hazardous
area immediately.
•
The device must be switched off immediately if it is likely that as a consequence of
damaging impact or general peculiarities the device can no longer be safely operated (e.g.
ingress of water, fluids, impact of temperatures beyond the specified range).
•
Do not insert any sharp objects into the enclosure or any other openings of the devices.
Any openings at the device must not be covered or blocked.
•
The intrinsically safe circuits must be installed according to applicable regulations.
•
The handheld scanners / IDM160BT-Z1 base loading station must be connected to
intrinsically safe circuits.
•
The safety values of the handheld scanners / IDM160-BT-Base-BT-Z1 base loading
station must match those of the device to which it is connected.
•
Interconnecting several devices in a single intrinsically safe circuit can result in different
safety characteristic values. This could compromise intrinsic safety !
•
National safety and accident prevention rules.
•
Generally accepted technical rules.
•
Safety instructions contained in these operating instructions.
•
Any damage may compromise the explosion protection.
NOTICE
CAUTION
Summary of Contents for IDM160
Page 35: ......