271489 / 8040621300
2019-04-15·BA00·III·en·00
Mounting and Installation
13
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Installation Switch
Series 8040/11-V30
7.3.1 Electrical Connection
Circuit diagram of the device with connection designations and possible versions.
Observe the following points during the installation:
• One or two conductors can be installed to one connection terminal.
• In case of solid conductors, both conductors must have the same cross section and
must be made of the same material.
• The conductors can be connected without special preparatory measures.
DANGER
Explosion hazard as a result of incorrectly installed components!
Non-compliance results in severe or fatal injuries.
• Ensure that the conductor insulation goes all the way to the
terminal points.
• Do not allow the conductor to be damaged during stripping
(e.g. by scoring).
• Select suitable conductors and install them so that the maximum
permitted conductor temperature and the maximum permitted
surface temperature are not exceeded.
• Install the conductors so that mechanical damage to the conductor
insulation due to rubbing against sharp edges or moving metal
parts is prevented.
• Only use suitable tools to fit the core end sleeves (if necessary)
so that they are gas-tight.
• Always connect the protective conductor.
• Note the tightening torque for the clamping units.
08804E00
08805E00
On-Off switch
Two-way circuit
24
14
24
14
270°
180°
90°
13 23
23
13
X
0°/360°
X
90° 180°
270°
0°
X
X
24
12
240°
180°
120°
60°
11 23
23
11
X
0°/360°
X
6 x 60°
X
X
24
12
300°
X
X
