Mounting and Installation
12
129916 / 8018602300
2016-09-27·BA00·III·en·03
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
LED Illuminated Pushbutton
for Panel Mounting
Series 8018/3
7.3
Installation
7.3.1 Electrical Connections
• Please observe the information given in the "Technical data" chapter.
• The conductor must be connected carefully.
• The conductor insulation must reach the clamping units.
• Do not damage the conductor (nicking) when stripping it.
• Ensure that the maximum permissible conductor temperatures and the maximum
permissible surface temperature are not exceeded by selecting suitable electric lines
and means of running them.
• Avoid mechanical damage to the conductor insulation due to rubbing it against
sharp-edged or moving metal parts.
DANGER
Explosion hazard due to incorrect selection of the type of protection!
Non-compliance results in severe or fatal injuries.
• Within a hazardous area, connect only conductors in a type of
protection corresponding to the zone.
CAUTION
Danger of electric shock due to energised parts!
Non-compliance can result in minor injuries!
• All connections must be disconnected from the power supply.
• Secure the connections against unauthorized switching.
Operation under difficult conditions, such as, in particular, on ships, requires
additional measures to be taken for correct installation, depending on the
place of use. Further information and instructions on this can be obtained
from your regional sales contact on request.
