P a g e |
18
P a g e |
18
DOC 001 REV A
DOC 001 REV A
P a g e |
19
REPAIR AND MAINTENANCE:
Tools Req’d:
• 2.5, 4, 5, 6 mm Allen Wrench
• 8, 10, 15 mm socket or open end/box end wrench
• T-10 Torx driver
Turn power switch to “OFF” position, remove battery, allow STACYC Stability Cycle
to cool before beginning repair or maintenance:
• Read instructions.
• Ensure the power switch is “OFF”.
• Ensure the battery is removed and STACYC stability cycle has had adequate time to
cool. (up to 30 minutes)
• Secure the STACYC stability cycle for repair or maintenance.
• Exercise caution around exposed parts.
• Contact STACYC customer service if unsure about any repair or maintenance.
Replacement Parts:
For the complete selection of replacement parts visit www.STACYCstabilitycycle.com
Repair Centers:
For a list of authorized STACYC service centers, check Online at:
www.STACYCstabilitycycle.com
Test Brake:
1. Squeeze brake lever and hold.
2. Push stability cycle forward. The rear wheel should not spin if brake is adjusted
properly.
3. If rear wheel spins when pushed forward or brake lever engages prematurely,
refer to “Adjust Brake”.
Adjust Brake:
1. To adjust brake cable:
a. Twist brake lever adjuster in or out, 1/4 to 1/2 turn at a time, until
desired brake adjustment is attained.
b. If brake still needs further adjustment, proceed to step 2.
2. Determine if brake cable has too much slack or brake rotor is dragging on
brake pad:
a. Loosen brake hub barrel adjuster.
b. Adjust brake hub adjuster in or out until desired brake adjustment
is attained.
c. Lock brake hub barrel adjuster.
d. Perform final adjustment of tension in brake cable with brake lever
barrel adjuster.
e. Repeat “Test Brake” section above.
WARNING: Careful adjustment of brake is critical as the brake is capable of causing
the stability cycle to skid the tire throwing an unsuspecting rider. Test and practice
braking in an open area free from obstacles, in a straight line, until child is familiar
with the brake function. Avoid skidding to a stop as this can cause child to lose con
-
trol or damage the rear tire.
WARNING: Motor and Electronic Speed Controller (ESC) can be very hot and cause
burns. It is critical that the STACYC Stability Cycle is allowed to cool prior to access-
ing motor and ESC!
WARNING: To prevent shock, please follow the instructions accordingly and do not
skip any steps.
Replace Fuse:
1. Place power switch in “OFF” position.
2. Remove battery from stability cycle.
3. Remove foot rest.
4. Remove right side panel, allow motor and ESC adequate time to cool before you
proceed.
5. Locate fuse. Remove the fuse from socket. Verify that replacement fuse is the
specified amperage. Replace fuse.
6. Re-Install right side panel.
7. Install the footrest.
Brake Lever barrel adjuster
Brake Hub barrel adjuster
◀
◀
Fuse located inside of down tube
◀
