To enter your own security code you will need to
follow the steps listed below:
1. After opening the electronic safe (with the preset
factory code of
1, 5, 9, #
) locate the small red
button on the inside of the door near the hinge.
2. Press the red button and then release it, you will
hear a beep. The yellow light on the faceplate will be
activated and will stay on for a period of time that
should allow you to enter your code. You can only
enter your code while the yellow light is on.
If the code fails, go through steps 1 and 2 again. If the
code works successfully record your combination
number on the front of this form or store your
combination on our secure website at
www.stack-on.com under Customer Service. If you
write down your combination you must keep this
information in a secure place, away from children, not
inside the safe. Then you should close and lock the safe.
If the incorrect security code is entered 3 times you
will have an automatic lockout for 15 seconds
before you can try your code again. If the incorrect
code is entered 2 additional times you will have a 5
minute lockout before you can try your code again.
With the door open and the yellow light on, enter
your own personal security code, which can be 3 - 8
digits long, and confirm your new code by pressing
the "
#
" symbol on the electronic touch pad.
Before you close the door, try the new security code
to make sure the lock releases the handle so you can
turn it and retract the live action bolts.
DO NOT SHUT THE DOOR UNTIL YOU
HAVE CONFIRMED THAT YOUR NEW
SECURITY CODE HAS BEEN ENTERED AND
WORKS CORRECTLY.
ENTERING YOUR SECURITY CODE
NOTE: If you press the wrong number while
entering a security code, you can press “ ” to erase
that entered number.
LOCKING THE SAFE
To lock the safe, close the door and rotate the
handle counter clockwise until it stops. If the
handle is not turned until it stops, the locking
mechanism will not lock.
NOTE ON LOCKING THE SAFE: Because
the locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination is entered, wait a minimum of 6
seconds from the time the combination is entered
to lock the safe.
SELECTING A LOCATION
The safe should be flat against the wall and floor.
Remove the baseboard if necessary.
The safe must be mounted to the floor. For
optimal safety and security, the safe should be
installed adjacent to a side wall with minimal
space on either side of the safe, in an isolated,
dry and secure area.
CHILDREN SHOULD NOT PLAY
WITH OR AROUND THE SAFE AT
ANY TIME.
To open the safe, first press any key to activate the
keypad, then enter the security code you have set
followed by the "
#
" symbol.
TURNING THE KEYPAD SOUND OFF/ON
You can turn off the "Beep" sound of the keypad by
entering the code
6 3 3
.
To turn the "Beep" sound on, enter the code
6 6.
40356-1409
3
21
