ENTERING YOUR SECURITY CODE
ELECTRONIC LOCK
After installing the battery, to open the electronic
lock the first time, first press any key to activate the
keypad, then press the following numbers/symbols
on the electronic keypad in this order:
1 - 5 - 9 - #
.
These numbers are preset.
NOTE: You should change the entry code as soon
as possible after opening the safe to insure proper
security.
After you have entered the factory code, you will
need to turn the handle clockwise to open the door.
You will have 5 seconds to turn the handle before the
locking mechanism is reactivated.
Before you can enter any numbers, touch any key on
the keypad to activate it. The keypad will stay
illuminated for approximately 10 seconds.
NOTE: The red reset button located on the
inside of the door, is covered with a removable
red cap. When you use the red reset button
while setting your own combination, remove
the cap to access the button.
Replace the cap securely over the reset button
after setting your combination. Failure to do
so will compromise the safety and security of
the safe.
40708-1607
3 18
To enter your own security code you will need to
follow the steps listed below:
1. After opening the electronic safe (with the preset
factory code of
1, 5, 9, #
) locate the small red
button on the inside of the door near the hinge.
2. Press the red button and then release it, you will
hear a beep. The yellow light on the faceplate will be
activated and will stay on for a period of time that
should allow you to enter your code. You can only
enter your code while the yellow light is on.
If the code fails, go through steps 1 and 2 again. If the
code works successfully record your combination
number on the front of this form or store your
combination on our secure website at
www.stack-on.com under Customer Service. If you
write down your combination you must keep this
information in a secure place, away from children,
not inside the safe. Then you should close and lock
the safe.
If the incorrect security code is entered 3 times you
will have an automatic lockout for 15 seconds
before you can try your code again. If the incorrect
code is entered 2 additional times you will have a 5
minute lockout before you can try your code again.
With the door open and the yellow light on, enter
your own personal security code, which can be 3 - 8
digits long, and confirm your new code by pressing
the "
#
" symbol on the electronic touch pad.
Before you close the door, try the new security code
to make sure the lock releases the handle so you can
turn it and retract the live action bolts.
DO NOT SHUT THE DOOR UNTIL YOU
HAVE CONFIRMED THAT YOUR NEW
SECURITY CODE HAS BEEN ENTERED AND
WORKS CORRECTLY.
NOTE: If you press the wrong number while
entering a security code, you can press “ ” to
erase that entered number.
To open the safe, first press any key to activate the
keypad, then enter the security code you have set
followed by the "
#
" symbol.
