BATTERY INSTALLATION
You must first install the battery which is located in
the front protective styrofoam.
NOTE: When changing the battery, always hold the
battery connecting cap while disconnecting or
attaching the battery. Do not pull on the wires.
Doing this could cause the power supply to become
disconnected from the lock.
This safe uses one 9V alkaline battery. Under normal
use, batteries will last about 1 year.
When the battery is low and you press a button on
the keypad, a red light will come on warning you that
the battery is low.
To test the battery, enter your security code. If the
battery is low the red light will come on
momentarily.
To replace the battery, remove the cover by pressing
the tab and turning the cover as shown in the
illustration. Replace the old battery and screw the
cover back in place.
TAB
IMPORTANT:
Your safe is delivered with a Safety
Interlock Screw which must be
removed in order for you to lock your
safe. Failure to do so will
compromise the safety and security
of your safe.
First open the safe by turning the handle
clockwise and pulling the door open.
Locate the Safety Interlock Screw on the side of
the door; unscrew with a Phillips screwdriver,
remove and discard the screw.
Your safe can now be closed and locked. Do not
lock your instruction manual and/or keys in the
safe. You will need this manual for the
instructions on locking and unlocking the safe.
Safety Interlock Screw
40708-1607
2 18
Image does not necessarily reflect the
configuration of your safe.
