FOAM PLACEMENT
SCOPE STANDOFF ASSEMBLY
Place the foam pads on the shelves and bottom as shown. The bottom foam
cut out piece may be used if the tactical stock rest is not used or may be cut to
produce a smaller piece to fill in behind the stock rest.
The scope standoffs can be mounted in the front (2) positions of the barrel
rests located on the left or right side. Use a type “B” screw and assemble the
standoff to the barrel rest as shown.
Insert the plastic plugs in the cabinet's top mounting holes if you are not
installing the Tactical Gear cabinet on the top the security cabinet.
Put your tactical guns in place to determine the best location for the stock rest
in the bottom of the center compartment. Peel away the adhesive backing and
press the stock rest into place.
40350-1309
27
6
B
Assemble the cabinet to suit your storage needs and load the cabinet
with your guns and equipment. If you are satisfied with your cabinet
configuration, proceed with mounting the cabinet to the wall and the
floor as described later in these instruction.
