40260-1202
12
2
Repeat scanning the same finger while listening for the single “beep” for
each successful scan. As you continue to scan, the scanner is “learning” your
fingerprint. After a minimum of 5 scans and possibly many more, the safe
will eventually “beep” 2 times indicating the fingerprint has successfully
been recorded.
1. To record a fingerprint, press the Reset Button (6) on the inside of the
safe. One “beep” will sound and the green light will start to flash.
If the finger scan happens to fail, the red light will flash and there will be 4
“beeps”. Continue to scan after the green light goes on but be aware that 3
failed scans will result in the termination of the recording session. You will
then have to start over from step 1.
2. While the green light is flashing, slide a finger across the scanner. When
you hear a single “beep”, the scan has been successful.
3. Repeat steps 1 and 2 to record up to 28 fingerprints. If you try to record
more than 28 fingerprints, the red light will flash and there will be 4 “beeps”.
For security you must record your fingerprint.
You can record up to 28 fingerprints
RECORDING FINGERPRINTS
Locate the safe at a height that allows easy
access to the fingerprint scanner.
Record several of your fingerprints in case you sustain a cut or an injury to a
finger you have scanned.
Make sure your entire fingerprint crosses the scanner.
Use a similar scanning motion when opening the safe.
If your hands have oil, lotion or are dirty the fingerprints may not scan
correctly.
In order to improve the rate of fingerprint
identification please follow these suggestions:
TIPS FOR RECORDING FINGERPRINTS
Scan your finger by sliding it over the scanner
in a straight and even manner from back to
front taking 1 to 2 seconds to make the scan.
Correct
Incorrect
Reset Button
OPENING THE SAFE USING A RECORDED FINGERPRINT
The scan has been successful if there are 2 “beep” and the green light flashes.
The safe door will open.
1. Press the START button (2). There will be a one “beep” and the green
light will go on.
2. Slide a recorded finger across the scanner while the green is on.
To close the safe, push the door closed until locked.
START button
If the finger scan happens to fail, the red light will flash and there will 4
“beeps”. Try to scan your finger again after the green light goes on but be
aware that 3 failed scans will result in the scanner shutting down. You will
then have to start over from step 1.
