Remove the shelf for better access to the battery compartment. Push the battery
cover locking tab with a screwdriver to release the cover. Install the (4) AA
alkaline batteries as shown. Replace the cover by inserting the rear tabs in the
slots and snapping the cover in place.
NOTE: If the batteries are low the red indicator will stay on after scanning.
Replace with 4 new AA alkaline batteries as shown.
NOTE: Do not mix old and new batteries. Do not mix alkaline, standard or
rechargeable batteries.
1.
Key lock
2.
START button
3.
Fingerprint scanner
4.
Red indicator light
5.
Green indicator light
6.
Reset button (inside safe)
7.
Battery Compartment (inside safe)
40260-1202
12
1
Record the serial number from the tag on the door front.
Tools required: Flat head screwdriver, 10mm wrench, drill, 3/8”
(9.5mm) drill bit.
Keep keys in a secure place away from children.
DO NOT store keys or this form in the safe.
When you first install the batteries, you can open the safe by pressing the
START button (2). For security you must record your fingerprint after you
install the batteries so the safe will read only the recorded fingerprints.
Instructions
CONTROL FEATURES
When you first receive your safe you will need to open the door with the key
in order to install the batteries. Batteries are included and are located
inside the safe.
GETTING STARTED
INSTALLING THE BATTERIES
To open the safe, insert key into lock and turn clockwise until the door
automatically opens. NOTE: You must turn the key back to the locked
position before you are able to close and lock the door.
Serial #:
NOTE: This key has also been provided if the batteries run low. If you
lose your key, you may purchase a replacement key by referencing the
serial number located on the front of the door. See section regarding
replacement keys for further information.
