BACK UP KEY
A "Back Up Key" has been provided in case you have
forgotten or lost your security code. To open the
safe using the back up key follow the steps below:
1. Remove the cover by pressing the tab and turning
the cover as shown in the illustration. The lock can
hang by the connecting cable while unlocking the
safe.
2. Insert the key in the key hole and turn clockwise
1/4 turn (until stopped) in order to unlock the safe.
Rotate the handle and open the door.
3. Keep the door open until you have entered a new
security code. Before entering your new code,
remove the key and screw the cover back in place.
4. Enter your new security code following the
instructions for entering your security code.
SECURING THE SAFE
1
Secure the safe with the fasteners and replace the
carpeting.
Use these holes to fasten the safe to the floor. Drill
the appropriate diameter and depth of pilot holes
into the floor depending on the type of hardware
being used and the type of floor surface. (Figure 2)
To secure your safe to the floor it will first be
necessary to drill pilot holes through the fire
insulation in the floor of the safe. First place the safe
in the desired location. Lift the bottom carpeting up
to find the two hole locations marked on the floor
insulation. Drill holes through the insulation using
the same diameter drill as the diameter of the
mounting hardware you are using.
IMPORTANT: The fasteners you use must
completely fill the hole you drilled into the
insulation. (Figure 1) You must use the fasteners
after you drill the holes. Failure to do so will void the
fire rating.
2
NOTE: The safe must be secured to the floor.
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
NOTE: This safe must be mounted to the floor.
Failure to do so will compromise the safety and
security of the safe.
TAB
40529-1504
4
24
